Installation Instructions

AERATOR INSTALLATION

  1. Remove existing housing unit
  2. Clean away any lime scale in the tap especially the thread area
  3. Ensure all the aerator components are flush and Sitting Square
  4. The washer must only be placed on top of the aerator and not pushed down
  5. Screw the Aerator directly into the tap ensuring it is not at an angle, do not over-tighten
  6. Turn on the tap and check for leaks.
  7. If you have a leak then the aerator is not inserted correctly, remove and go back to step three

Neoperl Tap Aerator Installation Key available here

ONLY USE NEOPERL INSTALLATION KEY!

OTHER TOOLS MAY CAUSE DAMAGE TO BOTH THE TAP AND THE AERATOR


TAP INSERT INSTALLATION

  1. Remove existing housing unit
  2. Clean away any lime scale in the tap especially the thread area
  3. Ensure all the aerator components are flush and Sitting Square
  4. Replace the old insert with new (The washer must only be placed on top of the aerator and not pushed down)
  5. Screw the Aerator directly into the tap ensuring it is not at an angle, do not over-tighten
  6. Turn on the tap and check for leaks.
  7. If you have a leak then the aerator is not inserted correctly, remove and go back to step three

ONLY USE NEOPERL INSTALLATION KEY!

OTHER TOOLS MAY CAUSE DAMAGE TO BOTH THE TAP AND THE AERATOR


SHOWER SAVER INSTALLATION

  1. Remove The Shower Head From The Hose
  2. Screw The Saver Onto The Shower Head
  3. Attach The Hose To The Other End Of The Shower Saver
  4. Not Use Any Tools As This Could Damage The Shower Saver
  5. If It Does Not Fit Or A Leak Is Detected, Please Go Back To Step 2.

GASKET WASHER

This item can be used:

  1. Between the shower hose and head
  2. Ensure the raised middle with the mini washer is facing the direction of the water flow